Panel Mount - DFI KS150 Installation Manual

Panel mount

The panel mounting kit includes the following:
• 10 mounting clamps
1. Before starting any installation procedures, attach the poron foam to the
Panel PC.
2. Select a place on the panel (or wall) where you will mount the Panel PC.
3. Cut out a shape on the panel that corresponds to the Panel PC's rear
dimensions (15": 367mm x 300mm; 19": 447mm x 380mm; 21.5":
526.2mm x 342.6mm) and ensure that the Panel PC can be fitted into
the panel properly.
Mounting hole
Panel
4. Insert the Panel PC from the outside surface of the panel into the
mounting hole until it is properly fitted against the panel.
5. Position the mounting clamps along the rear edges of the Panel PC and
insert them into the slits around the Panel PC. Note that the following
diagram is for illustration only and may not resemble the actual product.
300
367
13