Table of Contents
Advertisement
5.
Slide the Panel PC to "wall mount bracket 1" to attach the two brackets with the hooks.
Then tighten the screw to secure the assembly in place.
Chapter 6 Mounting Options
Chapter 6
Screw
30
Panel Mount
Note:
The system unit used in the following illustrations may not resemble the actual one.
These illustrations are for reference only.
The panel mounting kit includes the following:
•
6 mounting clamps
1.
Select a place on the panel (or wall) where you will mount the Panel PC.
2.
Cut out a shape on the panel that corresponds to the Panel PC's rear dimensions: (383+2)
mm x (310+2) mm (plus 2 to allow for tolerances) and ensure that the Panel PC can be
fitted into the panel properly.
5
Mounting hole
Panel
3.
Insert the Panel PC from the outside surface of the panel into the mounting hole until it is
properly fitted against the panel.
4.
Position the mounting clamps along the rear edges of the Panel PC and insert them into the
slits around the Panel PC.
385
210.50
www.dfi.com
Advertisement
Table of Contents
