Table of Contents
Advertisement
Panel Mount
Step 1:
Select a place on the panel (or wall) where you will mount the Panel PC.
Step 2:
Cut out a shape on the panel that corresponds to the Panel PC's rear dimensions (217.6mm x
127.6mm) and ensure that the Panel PC can be fitted into the panel properly.
The flat panel thickness is less than 10mm. Be sure to route or trim down the thick wall to 10
mm or slightly less for the clamps to recess and be compatible with your wall or enclosure.
Step 3:
Insert the Panel PC from the outside surface of the panel into the mounting hole until it is
properly fitted against the panel.
Step 4:
Position the mounting clamps along the rear edges of the Panel PC and insert them into the
slits around the Panel PC.
User's Manual | VP070-M8M
Step 5:
The first and second clamps must be positioned and secured diagonally prior to mounting the
rest of the clamps. Tighten the clamp's screw using an electric screwdriver by pressing the
white plastic cap onto the back of the panel. The illustration below shows that all clamps are
properly mounted.
Chapter 2
HARDWARE INSTALLATION
15
Advertisement
Table of Contents
