System Setting - Skyrc T100 Instruction Manual

The system will be set to its default parameters when powered on for the first time. The
screen displays the following information in sequence and the user can change any given
value on each screen.
To change a parameter value in the program, press START/ENTER to make that value
blink. Next, change the value by pressing INC or DEC. The value will be stored by
pressing START/ENTER once.
ITEM
S a f e t y T i m e r
O N 1 2 0 M i n
C a p a c i t y C u t - O f f
O N 5 0 0 0 m A H
T100
SELECTION
When you start a charge process, the
integral safety timer automatically starts
running at the same time. This is
OFF/
programmed to prevent overcharge the
ON
battery if it proves to be faulty, or if the
1-720 Min
( )
termination circuit cannot detect the
battery full. The value for the safety timer
should be generous enough to allow a full
charge of the battery.
This program sets the maximum charge
capacity that will be supplied to the
OFF/
battery during charge. If the delta peak
ON
voltage is not detected nor the safety
( timer expired by any reason, this feature
100-50000 mAh)
will automatically stop the process at the
selected capacity value.

SYSTEM SETTING

DESCRIPTION
21 ·