Skyrc T100 Instruction Manual page 17

NiMH/NiCd Re-Peak Mode:
Applicable to NiMH and NiCD batteries only, in re- peak mode the charger can peak
charge the battery once, twice, or three times in a row automatically. This process is
good for confirming that the battery is fully charged and for verifying how well the
battery can accept a fast charge. A five-minute cool-down delay occurs after each
re-peak charge.
IN RE-PEAK MODE, THE T100 USES THE CHARGE AMPERAGE AND VOLTAGE
SETTINGS ENTERED IN CHARGE MODE.
NiMH RE-PEAK
2
START/ENTER
NiMH 1.3A 10.42V
RPC 004:04 00686
T100
NIMH/NICD BATTERY PROGRAM
After selecting the correct battery type, use the INC or DEC
button to select the "RE-PEAK" mode. Press the START
button and the Re-peak cycle number 1 begins to flash on
the screen. Use the INC or DEC button to scroll through the
cycle count and set a number between 1 and 3.
Press and hold the START button for 3 seconds to start the
re-peak process.
Once the Re Peak process has begun, the charger will display
the following real-time information: battery type, charging
current, battery voltage,Working Mode, elapsed time and
charged capacity. Once the Re-P eak proceshas completed,
the screen will read "FULL"and the charger will emit a ringing
sound. The charger will display the charge/discharge capacity
for each cycle. Using the + and - buttons, you can scroll
through the history data of each cycle.
15 ·