Nl Oorspronkelijke Handleiding; Nederlands - Hilti DX 9-ENP Original Operating Instructions

Trouble or fault
No fastener is driven.
Base plate cannot be
screwed fully into place.
The tool cannot be pressed
fully against the working sur-
face
8 Disposal
Most of the materials from which Hilti tools and appliances are manufactured can be recycled. The
materials must be correctly separated before they can be recycled. In many countries, your old tools,
machines or appliances can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative
for further information.
9 Manufacturer's warranty
▶ Please contact your local Hilti representative if you have questions about the warranty conditions.
Oorspronkelijke handleiding
1 Informatie over documentatie
1.1 Over deze documentatie
• Lees voor ingebruikname deze documentatie door. Dit is vereist voor veilig werken en storingsvrij gebruik.
• De veiligheidsinstructies en waarschuwingsaanwijzingen in deze documentatie en op het product in acht
nemen.
• De handleiding altijd bij het apparaat bewaren en het product alleen met deze handleiding aan andere
personen doorgeven.
1.2 Verklaring van de tekens
1.2.1 Waarschuwingsaanwijzingen
Waarschuwingsaanwijzingen waarschuwen voor gevaren bij de omgang met het product. De volgende
signaalwoorden worden gebruikt:
32

Nederlands

Possible cause
Fastener or fasteners jammed in
the fastener guide
The piston stopper is fitted the
wrong way round
The piston guide is clogged with
dirt behind the connecting thread.
The rotating sleeve is not fully
closed.
The nail detector is jammed.
Part of the nail detector is broken.
No fasteners loaded in the tool
Action to be taken
▶ First remove the cartridge strip
and then remove the jammed
fastener.
▶ Avoid shear breakages of the
fasteners. Avoid missing the
beam. It may be necessary to
mark the position of the beam
better in future.
▶ Unscrew the base plate, insert
the piston stopper the right way
round and screw the base plate
on again → page 27.
▶ Clean the piston guide.
▶ Lubricate the connecting
thread.
▶ Close the rotating sleeve.
→ page 25
▶ Clean the base plate and
remove all foreign objects.
Take care to ensure adequate
lubrication of the fastener strip
guides with Hilti lubricant spray.
▶ Check for correct operation of
the nail detector by checking
that the tool is ready for use
→ page 24.
▶ Load the tool with fasteners.
2241307
*2241307*