Hilti DX 9-ENP Original Operating Instructions page 31

4 Technical data
4.1 Technical data
Weight in accordance with EPTA procedure 01
Dimensions (L × W × H)
Magazine capacity
Suitable cartridges
Suitable fasteners
Fastener driving rate
Thickness of the supporting steel
Compression stroke
Contact pressure
Application temperature (ambient temperature)
4.2 Noise information
The noise values listed were determined under the following conditions:
General conditions for noise measurements
Direct fastening tool
Model
Caliber
Power setting
Application
Noise information in accordance with EN 15895
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Sound (power) level (L
WA
Uncertainty for the sound power level (K
Peak sound pressure emission level (L
Uncertainty for the peak sound pressure level (K
4.3 Vibration
The vibration value that must be specified in accordance with 2006/42/EC does not exceed 2,5 m/s².
5 Operation
5.1 Preparations at the workplace
5.1.1 Establishing the position of the fasteners
To avoid incorrectly driven fasteners, proceed as follows:
▶ Each time you lay a metal sheet in position on the steel beams, use a water-resistant pen to mark the
area in which fasteners can be driven.
Do this each time, for each individual metal sheet. It is not sufficient to simply mark the ends of
the beam and then draw a straight line between these points as the supporting beams may be
distorted, i.e. curved.
*2241307*
)
pA
)
pA
)
)
WA
)
pC, peak
2241307
DX 9–ENP
12.5 kg
985 mm × 365 mm × 175 mm
40 nails / 40 cartridges
6.8/18 M40 red, black, blue
X­ENP 19
1,200 rev/h
≥ 6 mm
89 mm
≥ 250 N
−15 ℃ ... 50 ℃
DX 9–ENP
Series
6.8/18 black
4
Fastening to steel plate (Brinell
hardness 610 N/mm
X­ENP­19 L15MXR
103 dB(A)
2 dB(A)
113 dB(A)
2 dB(A)
137 dB(C)
) 2 dB(C)
pCpeak
) using the
2
English 23