Fayat BOMAG BT 60/4 Operating And Maintenance Instructions Manual page 18

Working on the engine
When working on the air filter no dirt should fall
into the air duct.
Do not work on the hot exhaust - danger of burn-
ing!
When working on the engine exhaust duct no com-
bustion residues should fall into the cylinder.
Do not touch the piston with the cleaning tools.
Working on the tamper foot
Wipe off spilled oil, catch running out oil and dis-
pose of environmentally.
Store oil contaminated materials in a separate,
specially marked container and dispose of envi-
ronmentally.
Cleaning work
Do not perform cleaning work while the motor is
running.
Do not use gasoline or other easily inflammable
substances for cleaning.
When using a steam cleaner for cleaning do not
subject electrical parts and insulation material to
the direct jet or cover these items beforehand.
Do not guide the water jet directly into air filter, ex-
haust pipe and air intake opening.
After maintenance work
After all maintenance work is completed reinstall
all guards and safety installations.
Repair
Repairs must only be carried out by qualified and
authorized personnel. Always follow our repair in-
structions.
Exhaust gases are highly dangerous! Always en-
sure an adequate supply of fresh air when starting
in closed rooms!
Attach a warning tag to the steering bow if the ma-
chine is defective.
Do not mix the nozzle in the carburettor up by
l
mistake.
Adjust the idling speed regulator screw exact-
l
ly.
Do not damage the blower wheel when work-
l
ing on the magnetic ignition.
Always replace self locking nuts.
l
BT 60/4, BT 65/4
Do not open the foot cover on the tamper foot,
l
spring tension. Danger of accident!
Observe the prescribed tightening torques.
l
Information and safety stickers/decals
on the machine
Keep safety stickers in good and legible condition
(see parts manual) and comply with their meaning.
Replace damaged and illegible stickers/decals.
BOMAG
Safety regulations
17