Orcon HRC-EcoMax Series Installation Manual page 33

7.2 Indication messages
I. Remote control 15RF
When a button on the remote control is pressed, the LED lights up green, then it will
flash to confirm. The following errors are possible:
Overview indications remote control RF15
Indication
Unit OK, message followed up
Unit OK, timer activated for 15 minutes
Unit OK, timer activated for 30 minutes
Unit OK, timer activated for 60 minutes
RF Communication problem
Configuration mode starting up
Successful connection with unit
Battery almost empty
Reset remote control carried out
Filter indication active
II. CO Roomsensor 15RF
2
When the LED on the CO
correctly and there is a connection to the ventilation unit
there is connection to the ventilation unit.
If the status LED flashes red 3 times, there is no radio-controlled communication
with the ventilation unit. Check whether the ventilation unit is connected to the
power supply. Register the CO
instructions. If a malfunction occurs in the CO
1x flash red repeatedly. Please contact the Orcon service department.
is permanently green, the CO
2
Roomsensor on the ventilation unit according to the
2
Remote control message
1x green
1x green
2x green
3x green
3x red
1x red 1x green 1x red
10x green
1x orange 2x green
2x orange
3x orange
Roomsensor is functioning
2
Roomsensor correct and
.
Roomsensor, then the status LED will
2
index
33