Orcon HRC-EcoMax Series Installation Manual page 20

• Resetting remote control 15RF
To replace a remote control, all components on the unit must be de-registered.
All components must then be registered again. A remote control can be reset
(and thus de-registered) by simultaneously pressing the ‹absent› and ‹timer› keys
for 3 seconds. The remote control indicates that the reset is complete when it
flashes orange twice.
Remote control
The remote control for the unit has 6 buttons. The functions of these buttons are
explained in the table below.
• Absent setting
In the absent position, the unit runs in an extra energy-efficient low setting and
does not respond to demand from the sensors.
• Timer setting
In the timer mode, the unit runs the desired time in the high position, after the
time has elapsed, the unit returns to the last selected position. The timer can be
cancelled by selecting another setting.
• Automatic mode
In car mode, the unit runs based on the moisture content in the home or based
on the optional CO
standard in position 1. When there is a ventilation demand from the humidity
sensor or the optional CO
setting (setting 2).
Explanation of remote control buttons
Button Operation
1x short
1 1x short
2 1x short
3 1x short
1x short
2x short
3x short
auto 1x short
20
sensors. If there is no ventilation demand, the unit runs as
2
, the unit will modulate the ventilation to the medium
2
Function
Absent setting (same as low setting)
Setting 1 (low setting)
Setting 2 (medium setting)
Setting 1 (low setting)
Setting 3 (timer mode) temporary 15 minutes
Setting 3 (timer mode) temporary 30 minutes
Setting 3 (timer mode) temporarily 60 minutes
Automatic mode
index