Orcon HRC-EcoMax Series Installation Manual page 23

There are 2 options:
• Energy-saving mode (green)
In this mode the unit will ventilate according to the standard requirement.
This saves on energy costs; ventilation is only done when it is really needed.
• Excellent mode (blue)
In this mode, the CO
As a result, more is ventilated so that the dirty air particles can be extracted
from the home faster and clean outside air is brought in.
5.3 CO Controlsensor 15RF
2
Mounting
The CO Controlsensor is mounted in the same way as the CO
2
Registration
• On 1 unit
Remove the HRC plug from the socket for 10 seconds. Then return the plug back
to the socket. The unit will remain in set-up mode for 3 minutes. Restart the CO
sensor by removing it from the wall frame and then replacing it. Briefly press the
control button once on the CO
now flash. Then hold down for 3 seconds until one LED on the right lights up and
the status LED flashes red and green alternately. Once the CO
been successfully registered, the green LED will flash 10x.
The CO Controlsensor is ready for use. To register an extra CO
2
repeat the above procedure.
• On multiple units
To register one CO
that the control button must now be pressed for 8 seconds until 2 LEDs on the
right-hand side of the CO
• Reset CO Controlsensor
2
A CO Controlsensor can be reset to factory settings by pressing the control button
2
for 17 seconds until the red and green LED light up simultaneously (orange).
Now release the push button. The CO
Roomsensor keeps the air quality level at a high level.
2
Controlsensor; the red LED on the control will
2
on multiple units, the above procedure is repeated, except
2
Controlsensor lights up.
2
2
2
Controlsensor restarts and has been reset.
Roomsensor.
Controlsensor has
2
Controlsensor
2
index
2
23