Orcon HRC-EcoMax Series Installation Manual page 24

Hide thumbs Also See for HRC-EcoMax Series:
Table of Contents

Advertisement

Operation
By tapping the control button once, the status is displayed by the LEDs. The LEDs will
go out again automatically after 30 seconds. This to make sure there is no distracting
lights in dark bedrooms, or forms a distraction in other living areas. If the remote
control button is touched again after holding down once, the CO
switch to another setting or mode.
CO
Controlsensor
2
Absent setting
Automatic setting
1
Setting 1
2
Setting 2
3
Setting 3
Absence and setting 1,2 and 3
A minimum amount is ventilated in the absent setting. This setting remains
active for 12 hours or until it is manually reset to automatic mode. Settings 1
(low), 2 (medium) and 3 (high) are temporary settings. If one of these settings is
selected, the system will return to automatic mode after 60 minutes. During this
setting the LEDs of the selected setting will remain lit.
Automatic mode
In automatic mode, the ventilator will ventilate based on the moisture and CO
content in the home. This saves on energy costs; ventilation is only carried out
when it is really needed.
5.4 Resetting the HRC
If you have replaced a component, you must first reset the HRC before registering a
new component. To do this, remove the printed circuit board cover on the top of the
unit. Hold down the push button on the central printed circuit board in the unit for
15 seconds until the LED lights up orange. Release the push button. The link with
the remote control/CO
been loaded. After this, the LED on the printed circuit board will remain in set-up for 3
minutes and can be linked with components.
If you need support with the installation of the above
components, you can always consult our instruction videos at:
www.orcon.nl/service/onderhoud/
24
Unit runs at the lowest possible setting
Automatic control based on moisture and CO
Temporary low setting (60 min)
Temporary medium setting (13 h)
Temporary high setting (60 min)
sensors has now been deleted and the factory settings have
2
Controlsensor will
2
2
2
index

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents