Orcon HRC-EcoMax Series Installation Manual page 21

5.2 CO Roomsensor 15RF
2
Mounting
The CO Roomsensor and CO
2
bottom. The remote control is supplied with 230V mains power. To connect the control
to 230V, open the cover for the power supply. This can be opened using a flat head
screwdriver. The wiring (max. 1.5 mm
into the wall frame and connected to the terminal block behind the cover.
The cover must be on at all times to protect the terminal block. The wall frame can
then be mounted with the 2 screws and plugs (not supplied) to a flush-mounting box
or wall. Caution: the push button on the wall frame must always be at the bottom.
Keep enough space free at the bottom so that the push button can be easily reached
from below. It is recommended to place the sensor near the thermostat or light switch
at a height of 1.5 metres in the living room or kitchen. Any additional sensors must be
placed in the other living spaces. Do not place the sensor near large metal objects and
mount it out of the reach of children.
Power supply cover
Push button
Air slots
Controlsensor can be opened via the push button on the
2
2
) for the 230V supply voltage, it can then be fed
Control button
Printed circuit board
(mounted in the upper part)
Power supply cover
index
Wall frame
Push button
21