Orcon HRC-EcoMax Series Installation Manual page 22

Register CO Roomsensor 15RF
2
• On 1 unit
Remove the plug from the HRC for 10 seconds. Then return the plug back to the
socket. The unit will remain in set-up mode for 3 minutes. Restart the CO
removing it from the wall frame and then replacing it. Press the control button on
the CO sensor once briefly, then hold down for 4 seconds until one LED on the right
2
lights up and the status LED flashes red and green alternately. The CO
is ready for use. Registering an extra CO
• Multiple units
To register one CO
the control button must now be pressed for 8 seconds until the two LEDs light up.
• Reset CO
Roomsensor 15RF
2
To replace a CO
components must then be registered again. A CO
settings by pressing the control button for 15 seconds until the red and green
LED lights up simultaneously (orange). Now release the push button.
Operating the CO
Status LED (red/green)
By tapping the control button once, the status is displayed by the LEDs. The LEDs will
go out automatically after 30 seconds. If the remote control button is touched again
after holding down once, the CO
Changing this mode can be recognised by the green or blue LED on the top right of the
CO Roomsensor lighting up.
2
22
sensor on multiple units, the above procedure is repeated, but
2
sensor, all components on the unit must be de-registered. All
2
Roomsensor 15RF
2
LED Energy-saving mode (green)
Control button
Roomsensor will switch to another mode.
2
sensor is done the same way.
2
sensor can be reset to factory
2
LED Outside
Excellent mode
(blue)
sensor by
2
Roomsensor
2
Wall frame
index