Orcon HRC-EcoMax Series Installation Manual page 30

index
Cleaning the heat exchanger
The heat exchanger can easily be taken out of the unit with the
help of the draw band. The heat exchanger must be cleaned with
lukewarm water (max. 40°C). Allow most of the water to drain
out and dry the heat exchanger as far as possible before replacing
it in the unit.
Caution: The exchanger must be replaced facing the same way as
when it was taken out of the unit. You can check this by aligning
the sticker on the exchanger with the sticker of the same colour
on the EPP housing.
Caution: when replacing, the heat exchanger fins should slide through the slots in the
EPP housing to prevent leakage between airflows and damage to the housing.
30