Orcon HRC-EcoMax Series Installation Manual page 29

• The humidity sensor can remain in
place or easily be removed from the
connector. It can then be cleaned
carefully using a dry brush.
• If the humidity sensor has been
removed for cleaning, replace it in
the connector after cleaning.
Caution: if the black dot on the sen-
sor is facing you, the red wire should
be positioned on the left side of the
connector (see the image opposite).
Then place the humidity sensor with
the black dot downwards in the
designated recess in the housing as
shown in the adjacent image.
• If the bypass module has been
removed to reach the moisture
sensor, replace it as shown in the
image below. Caution: pull the
bypass cable up at the same time.
Check whether the frame is stuck in
the housing at the points indicated
in the image below (green).
Red
Seen from below
index
White
29