SEW-Eurodrive MOVI-C CONTROLLER UHX65A Manual page 19

4.2 Mechanical installation
Risk of injury to persons and damage to property.
Never install defective or damaged MOVI-C
•
4.2.1 Minimum clearance and mounting position
MOVI‑C
installation:
•
•
•
•
CAUTION
Before installation, check the device for external damage. Replace any damaged
device.
®
CONTROLLER is installed in the control cabinet. Observe the following for
Install the device with the provided carrier plate to the metal bare back of the con-
trol cabinet.
To ensure unobstructed cooling of the MOVI-C
clearance of 100 mm above and below the device's housing as well as 20 mm to
the right and left. Make sure air circulation in the clearance is not impaired by
cables or other installation equipment. The preferred mounting position is left of
the axis system.
Ensure unobstructed
®
MOVI‑C CONTROLLER is not exposed to the warm exhaust air from other
devices.
Only install the device vertically. Do not install the devices horizontally, tilted or up-
side down.
®
CONTROLLERs.
®
CONTROLLER, leave a minimum
cooling air supply and
®
Manual – MOVI‑C CONTROLLER progressive UHX65A
Installation notes
Mechanical installation
make sure that the
4
19