Wall Mount Applications - Johnson Controls FEU2610 Series Installation Instructions Manual

Wall Mount Applications

To mount the FEU26 on a wall (or other vertical surface):
1. Ensure that all three mounting clips are pulled outward and snapped firmly into the extended position. See
.
Figure 2
Figure 2: DIN Rail and Mounting Clip Features on the Back of an FEU26, mm (in.)
2. Mark the location of the mounting holes on the wall using the dimensions in
orientation in
Figure 3
3. Drill holes in the wall at the locations marked in Step 2, and insert appropriate wall anchors in all three holes (if
necessary).
4. Hold the FEU26 in place, and insert the screws through the mounting clips and into the holes. Carefully tighten
all of the screws.
IMPORTANT: Do not over tighten the mounting screws. Over tightening the screws may damage the mounting
clips.
90
( 3-1/2 )
143
( 5-5/8 )
DIN Rail
Channel
127
5 ( )
48
( 1-7/8 )
. (Or hold the FEU up to the wall as a template and mark the hole locations.)
Figure 3: Required Orientation for Wall Mount Applications
FEU2610 Field Equipment Controller Installation Instructions
48
( 1-7/8 )
90
( 3-1/2 )
DIN Rail
Hooks
95
48
( 3-3/4 ) ( 1-7/8
Mounting Clips
(in Extended Positions)
4
)
and according to the
Figure 2