Removing A Line Module, Srp Module, Or Srp I/O Module - Juniper E Series Hardware Manual

E-series Hardware Guide

Removing a Line Module, SRP Module, or SRP I/O Module

48 !

Removing a Line Module, SRP Module, or SRP I/O Module

7. Insert the module into the midplane by simultaneously depressing both ejectors
(as shown in Figure 25) and exerting forward pressure on the module.
8. Tighten the module's captive screws using a Phillips screwdriver. Alternately
turn each screw several times before tightening them completely to allow the
module to sit correctly.
Although not required, it is recommended that you issue the slot disable
NOTE:
command from the CLI before removing a module.
If you do not use the halt command before removing or powering down
CAUTION:
an SRP, the system's NVS card may become corrupted.
To remove a line module, SRP module, or SRP I/O module:
1. For SRP modules and SRP I/O modules, issue the appropriate halt command
(halt, halt primary, or halt standby).
See JUNOSe System Basics Configuration Guide, Chapter 5, Managing Line
Modules and SRP Modules
2. Ground yourself by using an antistatic wrist strap or other device.
3. Use a screwdriver to loosen the thumb screws located at the top and bottom of
the module panel.
4. Pull the ejector handles located at the top and bottom of the module so that
they are in position 2, as shown in Figure 26.
for information about the halt commands.