Installing Sfps - Juniper E Series Hardware Manual

Figure 45: Possible release mechanisms on the SFP
Release bar, button,
or tab
5. Release the SFP and pull it out of the slot.
6. Place the SFP in an antistatic bag.
7. If you are using the redundant port on the E-series GE I/O module, repeat steps
CAUTION:
redundant ports on an E-series GE I/O module must use the same type of SFP.

Installing SFPs

To install SFPs:
1. Put the antistatic wrist strap on your wrist, and connect the strap to the ESD
2. Identify the following items on the SFP (see Figure 46):
! A ring that you press inward
A bar that you pull sideways, then outward
!
! A tab that you pull sideways, then outward
3 through 6 for the other SFP.
For port redundancy to operate correctly, both the primary and
grounding jack on your system.
! The connection circuitry on the base
! The cable connectors on the front
The cable connectors will be protected by a dust cover.
Chapter 9: Maintaining E-series Routers
Transceiver
Release bar, button,
or tab
Release ring
Module faceplate
Replacing SFPs on GE I/O Modules
! 91