Advertisement
User manual
4. Fine adjustment of the motor
1.)
Master Innovation's
The
speed deviations can occur during transportation or due to dirt or dust on the sensor or the sensor
ring. Please check the speed before using the turntable for the first time.
To correctly adjust the speed, put the recommended Clearaudio
platter and refer to the instructions provided in the
To check the speed with highest accuracy, you may wish to use the Clearaudio
(Art. No.: AC039, available at www.analogshop.de).
On the right front side of your turntable there are three fine speed adjusters (see Picture 16 below).
Pic. 16: Fine adjustment of the motor
To adjust the turntable speed at 33 1/3 rpm, take the screwdriver provided and turn the left adjuster
until you have reached the right speed according to the
user manual).
•
Turning the adjuster counter clockwise reduces the turntable speed.
•
Turning the adjuster clockwise increases the turntable speed.
You can also adjust the turntable speed for 45rpm and 78rpm in the same way.
Please note:
If the turntable does not reach the correct speed, the sensor or the scale ring could be dirty or
dusty. To clean the sensor, take off the two platters very carefully. Clean the sensor and the scale
ring with a little isopropyl alcohol and a cotton bud. Be very careful to avoid scratching the sensor
or the scale ring.
Should the motor still have speed variations, please contact Clearaudio directly or you're nearest
authorized Clearaudio dealer.
Now you are ready to play your vinyl records.
We wish you a great deal of pleasure with your new
Made in Germany
motor adjustment is already pre-set at the factory. However, some small
Stroboscope Test Record
Stroboscope Test Record
- Left adjuster = setting 33 1/3rpm
(near turntable motor)
- Middle adjuster = setting 45rpm
- Right adjuster = setting 78rpm
(near turntable bearing)
Stroboscope test record
Master Innovation
onto the
user manual.
Speed Light
(see the relevant
turntable.
15
Advertisement
