Table of Contents
Advertisement
10.4.7 Changing Reduction Case Oil
1. Allow the engine to cool before changing the
oil. Draining works best when the oil is warm.
CAUTION
BURN HAZARD
Hot oil can burn skin.
2. Be sure the engine key switch is in the OFF
position and the fuel valve is turned OFF.
3. Place a pan under drain plug. Remove the
drain plug and allow the oil to drain for ten
minutes.
4. Reinstall the drain plug and tighten.
5. Dispose of the oil in an approved container.
Follow industrial disposal regulations.
6. Fill the reduction case to the full mark on
the dipstick with SAE 20W-40 or 20W-50 oil.
Capacity is 0.52 US Qts. (0.5 liters).
7. Reinstall the dipstick securely into the
reduction case cover.
10.4.8 Clean Air Cleaner
Check and remove any debris from the foam
cover of the air cleaner daily before each use.
Thoroughly clean or replace the foam cover every
three months or 50 hours of operation (clean it
more frequently when used in dusty conditions).
10.5 CONVEYOR ROLLERS
Check conveyor rollers for damage and replace as
necessary. The conveyor trolley has four rollers
to roll the trolley up and down the channels in the
frame.
43
Advertisement
Table of Contents
