10.6 CONVEYOR ROTATION BRAKE
ADJUSTMENT
1. Make sure the trolley lock plate is engaged
to prevent the trolley from moving during
adjustment.
2. Turn the key to the "ON" position.
3. Activate the brake. There should be an
audible click from within the hub. If there is
not, make sure the battery is fully charged.
4. Remove the plugs from the adjustment slots
on the bottom of the hub.
44
5. Insert a screwdriver through the appropriate
slot and turn the brake adjuster. Clockwise
rotation will tighten the brake.
6. Make adjustments in 1/2 turn increments, and
test the brake action after each adjustment.
a. With the brake off, the conveyor should
stopwithintwelvetofifteenincheswhen
pushed.
b. With the brake on, the conveyor should
stopwithinfivetotenincheswhen
pushed.
c. It should not stop immediately, as this will
result in drag when the brake is released
and will make conveyor rotation more
difficult.
7. Continue the adjustment until the requirements
are met.
8. Whensatisfiedwiththebrakeaction,replace
the plugs in the adjustment access slots and
turn the key off.
MMG-00875
MMG-00874