Remote Control Handset; Changing Handset Sleep Time - Meridian 4055 SEED EXPRESS Operator's Manual

Operator's Manual: 4055 Seed Express

4.3.8 Remote Control Handset:

The handset is powered by two AA batteries. The
handset display window indicates the remaining
battery life. When batteries are new, the display
indicates 100% power. As the control is used,
the power decreases. When red indicator light
turns ON, the batteries should be replaced
immediately, or discontinue the using it.
Battery Replacement Tips:
• Check the batteries at least every six months
(for low Voltage, leakage, etc.).
• Always use the correct size and type of battery.
Replace old batteries with new 1.5 Volt AA,
alkaline batteries.
• Always replace both batteries at the same
time.
• Do not mix types, brands, or ages of
replacement batteries.
• Do not install the batteries backwards. Make
sure you insert the batteries with the + (plus)
and – (minus) terminals aligned correctly.
• Remove the batteries from the controller if not
expected to be in use for several months.
• Do not attempt to recharge a battery unless it
is specifically marked "rechargeable."
• Dispose of old batteries properly.
Battery Replacement:
1. Remove the two Phillips head screws from
the cover on the back of the unit.
2. Replace the batteries, making sure they are
correctly positioned.
11.2022
Bulk Seed Tender
™ ®
4.3.9 Remote Control Handset to Control
To reprogram the ID code to the receiver:
before it has completed or the system
1. Turn the handset and control panel OFF.
2. Press and hold the POWER button on the
handset for more than ten seconds.
- The handset LCD display will indicate
3. When directed, apply power to the receiver.
- Green LED stays on constantly when
4. When the process is completed, the green
LED will blink on and off.
- Test the handset transmitter to make sure

4.3.10 Changing Handset Sleep Time:

To change the sleep time on the handset:
1. With the handset off, press and hold ENGINE
STOP, CONVEYOR STOP and POWER
buttons.
2. Wait for a few seconds, then release the
buttons.
3. The green and red LEDs will start blinking
together.
4. Use CONVEYOR INC and CONVEYOR
STOP to increase/decrease the sleep time.
5. Select the desired sleep time.
6. Press POWER button to save and exit.
Panel Receiver Synchronization:
Note:
Do not interrupt this procedure
may not operate correctly.
when to apply power to the control panel.
reprogramming is in progress.
it functions properly.
®
4-11