Change Hydraulic Oil; Change Hydraulic Oil Filter - Meridian SEED TITAN 2XT Operator's Manual

Operator's Manual: Seed Titan™ 2XT Seed Tender

4.3.8 Change Hydraulic Oil:

1. Stop engine and remove ignition key before
maintaining.
HOT LIQUID HAZARD
Engine and hydraulics must cool before
changing the oil. Hot oil can cause burns
if it contacts exposed skin.
IMPORTANT:
Annually, have an oil sample
tested for particle count.
Change oil only if necessary.
2. Allow the hydraulics to cool slightly before
changing oil.
Note:
It is best to change oil
while the engine is warm (not hot)
to keep contaminants in suspension.
3. Place a large pan or pail under the drain plug.
- Reservoir capacity is 3 US Gal (11.4 Liters).
4. Remove drain plug and allow to drain for ten
minutes.
5. Install and tighten the drain plug.
6. Dispose of the used oil in an approved
container and manner.
7. Fill the reservoir with specified oil.
4-8

4.3.9 Change Hydraulic Oil Filter:

1. Place a pan under filter to catch any spilled
oil.
2. Remove hydraulic oil filter, and dispose of it.
3. Fill the new filter with hydraulic oil.
4. Apply a light coat of oil to the O-ring and
install the new filter. Snug up by hand and
then tighten another 1/2 turn.
5. Run the engine for 1-2 minutes and check
for oil leaks.
6. If leaks are found around the drain plug or
filter, tighten slightly.
7. Check oil level. Top up as required.
Fig 45 - Hydraulic oil filter
Fig 46 - Hydraulic oil filter
®
01.2020