Safety Sign Locations; Safety Signs; How To Install Safety Signs; Decal Locations - Meridian TITAN SR2 Operator's Manual

3. SAFETY SIGN LOCATIONS

3.1 SAFETY SIGNS

The types of safety signs and locations on the
equipment are shown in the following pages.
Good SAFETY AWARENESS requires that you
familiarize yourself with the various safety signs,
the type of warning and the area, or a particular
function related to that area.
1. If safety signs have been damaged,
AR
N I
removed, become illegible, or parts
replaced without signs, new signs must
be applied.
2. Replacement parts that displayed a safety
sign should also display the current sign.
3. Replacement safety signs (labels) are
available from your authorized Dealer Parts
Department or the factory at no cost.

3.2 HOW TO INSTALL SAFETY SIGNS

1. Be sure that the installation area is clean and
dry.
2. Be sure temperature is above 50°F (10°C).
3. Determine exact position before you remove
the backing paper.
4. Remove the smallest portion of the split
backing paper.
5. Alignthesignoverthespecifiedareaand
carefully press the small portion with the
exposed sticky backing in place.
6. Slowly peel back the remaining paper and
carefully smooth the remaining portion of the
sign in place.
7. Small air pockets can be pierced with a pin
and smoothed out using a piece of sign
backing paper.

3.3 DECAL LOCATIONS

1. NOTICE — Product Warranty (#18432)
2. Product Serial Number Decal (#19984)
6720110948768
Storm Lake, IA 50588
MMG-00871
17