Lubrication; Wheel Bearings; Battery; Battery Safety - Meridian TITAN SR2 Operator's Manual

10.2 LUBRICATION

Use "10.15 Service Record Chart" on page 52
in the Maintenance section to keep a record of all
scheduled maintenance.
1. Use an SAE multi-purpose high temperature
grease or a multi-purpose lithium base grease.
2. Use only a handheld grease gun for all greasing.
3. Wipegreasefittingswithacleanclothbefore
greasing to avoid injecting dirt and grit.
4. Replace broken zerks immediately.
5. If zerks will not take grease, remove and clean
thepassageway.Replacefitting,ifnecessary.

10.2.1 Wheel Bearings

Each axle is equipped with a grease zerk under
the center dust cap of the wheel. Add grease
sparingly to the wheel bearings, using only wheel
bearing grease. The wheel bearings should be
repacked annually. Check for excessive end play
and tighten, if necessary.
IMPORTANT
Over greasing wheel bearings can cause them to
overheat, resulting in damage and/or failure.

10.3 BATTERY

Inspect the battery at least once every six
months and before using the seed tender at the
beginning of the season. Always follow the safety
instructions when servicing a battery.
40

10.3.1 Battery Safety

1.   K eepallsparksandflamesawayfrom
batteries, as gas given off by electrolyte
is explosive.
2. Avoid contact with battery electrolyte:
wash off any spilled electrolyte
immediately because battery acid can
cause severe chemical burns.
3. Wear safety glasses when working
near batteries.
4. Do not tip batteries more than 45 degrees to
avoid electrolyte loss.
10.3.2 Battery Replacement and
Maintenance Tips
• Check the batteries at least every six months for
low Voltage, leakage, etc.
• Always use the correct size and type of battery.
Replace old batteries with a new SP-30 Lawn
and Garden battery with at least 225 CCA and
290 CA ratings.
• Do not install the battery cable to the wrong
terminal. Make sure the RED cable is connected
to the + (plus) terminal and the BLACK cable is
connected to the – (minus) terminal.
• Remove the batteries from the seed tender if not
expected to be in use for several months.
• Use recommended practices when recharging a
battery.
• Remove any corrosion from the battery post
using a wire brush terminal cleaner. Corrosion
can also be removed using a baking soda paste
and water to neutralize and remove the acid
from the battery terminals
• Dispose of old batteries properly.