Meridian TITAN SR2 Operator's Manual page 34

8. Make sure the trolley lock pin is engaged
to prevent the trolley from moving during
unloading.
Note: Whenever the conveyor is repositioned,
the rubber skirt, which directs the seed into
the conveyor, can move out of its normal
position. Before opening the slide gates,
make sure the rubber boot on the conveyor
completely surrounds the bottom of the bin
chute.
On single axle units, anytime the conveyor is
positioned toward the rear of the unit, away from
the tongue, the rear jack stand must be lowered to
support the weight of the conveyor.
WARNING
UPENDING HAZARD
Always maintain a positive tongue
weight. Negative tongue weight can
cause the hitch to rapidly swing upward
if not securely fastened to the tow
vehicle, which can result in personal
injury.
34
9. Press and hold the remote throttle switch to
move the throttle lever 1/3 the distance of the
full open position. An electronic actuator is
connected to the throttle lever to increase and
decrease the speed of the engine.
10. Start the gas engine.
a. Move fuel valve lever (1) to the ON
position.
b. To start a cold engine, move choke lever
(2) to the CLOSED position.