Table of Contents
Advertisement
5. Lower the hitch onto the ball.
6. Raise the jack and place it in its stowed
position.
7. Close the receiver lock lever and install the
retainer clip to prevent unwanted opening of
the receiver.
WARNING
If the safety chains are damaged in any
way, do not use the trailer until proper
chains are installed.
damaged safety chains could allow the trailer to
separate from the tow vehicle, resulting in
equipment damage, personal injury, or death.
8. Attach safety chains (3) securely to the tow
vehicle to prevent unexpected separation.
Cross the chains when attaching.
9. Connect wiring harness (4) with the seven-pin
connector for the lights and brakes.
10. Connect breakaway system cable (5) to the
tow vehicle. Make sure key (6) on the end of
the cable is properly plugged into the receiving
unit.
(Thephotoreflectsadifferenttrailermodel;however,
the hookup method is the same).
(The key must be completely plugged into the socket for
the system to operate properly).
Substandard or
11. Route all the cables in a manner that will
prevent snagging. Be sure to provide slack for
turning.
29
Advertisement
Table of Contents
