Gira 5431 00 Operating Instructions Manual page 7

Wireless dimming actuator, 4-gang
Switch position
min.
*) If the operating mode switch is turned from the position PC, the operating mode and
parameters are set to the default setting. The settings made with the eNet Server will
be lost.
When setting the minimum brightness, the parameter settings remain unchanged.
￭ Set the operating mode switch (2) for the load outputs A1...A4.
￭ Switch on mains voltage.
If outputs are switched in parallel, only set the operating mode switch of the master out-
put.
4.2 Commissioning
DANGER!
Electrical shock when live parts are touched.
Electrical shocks can be fatal.
During commissioning, cover the parts carrying voltage on radio transmitters and
actuators and in their surrounding area.
The actuator can also be commissioned with eNet Server as an alternative to the commis-
sioning described here.
Connecting output to radio transmitters
Load is switched off.
￭ Press button Prog (3) for longer than 4 seconds.
The status LED (4) flashes after 4 seconds. The output is in programming mode for
approx. 1 minute.
￭ Switch radio transmitter to programming mode (see radio transmitter instructions).
￭ Trigger telegram on the radio transmitter.
The status LED (4) of the corresponding output is illuminated for 5 seconds.
The output is connected to the radio transmitter. The output and radio transmitter exit the
programming mode automatically.
If the status LED of the actuator flashes 3 times at 1-second intervals for approx. 5
seconds, then the programming procedure was not successful. All the memory locations
in the actuator or radio transmitter are occupied.
All On and All Off buttons of a radio transmitter are connected to the output automatically
as soon as the first connection to the radio transmitter takes place. Scene buttons must
be connected separately.
If outputs are switched in parallel, the radio transmitters are only connected to the master
output.
Disconnecting connection to a radio transmitter
￭ Carry out the same steps as when connecting (see Connecting output to a radio transmit-
ter).
32578622 10867484
Function/connectable loads
ciple, dimmable HV-LED or compact fluorescent lamps that
can be dimmed according to the trailing edge phase control
principle. The connection of inductive transformers is not per-
mitted.
Setting of the minimum brightness
01.10.2019
7 / 19