Gira 5431 00 Operating Instructions Manual page 10

Wireless dimming actuator, 4-gang
Parameters
Operating mode
Channel assignment
Parameters
Parallel operation
Advanced device settings
Parameters
Manual commissioning
Channel settings
Parameters
Switch-on brightness
Minimum brightness
32578622 10867484
Setting options, Basic setting
Normal operation
Continuous on
Continuous off
Basic setting: Normal Opera-
tion
Setting options, Basic setting
Channel 1, 2, 3, 4
Channel (1+2), 3, 4
Channel (1+2+3), 4
Channel (1+2+3+4)
Channel (1+2), (3+4)
Basic setting: Channel 1, 2, 3,
4
Setting options, Basic setting
On, Off
Basic setting: On
Setting options, Basic setting
1...100 %
Basic setting: 100 %
1...67 %
Basic setting: 5 %
01.10.2019
Explanations
Normal operation
The output can be operated
with radio transmitters and the
Prog button.
Continuous on
The output switches to con-
tinuously "On". All operations
of radio transmitters and the
Prog button are ignored.
Continuous off
The output switches to con-
tinuously "Off". All operations
of radio transmitters and the
Prog button are ignored.
Explanations
Two to four outputs can be
switched together to boost
power. The parameter is only
changed over for the display
in the commissioning inter-
face. The actual setting must
be made on the device.
Explanations
Blocks manual commissioning
for the device channel.
Note: In the "Off" setting, the
device cannot be reset to the
factory setting.
Explanations
During brief operation, the out-
put switches on at the set
switch-on brightness.
Note: If the value is above the
set maximum brightness or
below the minimum bright-
ness, then the system will
switch to the appropriate limit
value.
Specifies the minimum set-
table brightness.
Note: If parameters or scene
values are set to a level lower
than the minimum brightness,
then the system will dim to
minimum brightness.
10 / 19