Jøtul GF 373 BF Installation And Operation Instructions Manual page 20

139807_R4 GF 373 BF CE 7/17
14. Pairing the Remote Control
Although the remote control is paired with the stove at the
factory, it may become necessary to cancel the pairing and
re-synchronize the two, follow the steps below.
NOTE: A new pairing can be made accidentally necessary by
pressing the (+) and (-) buttons on the remote control or on
the TESC valve control simultaneously for 5 seconds.
Resetting the remote control display to
factory settings
• Hold the remote control to unlock.
• Hold down the SET button until the remote beeps,
then release. PROG appears in the top left corner.
• Press and release the Mode button until the word
SETUP flashes in the upper right corner.
• Press and release SET to enter SETUP menu.
• Press and release the Set button about 9 times,
until the display indicates "CA" (Cancel All)
• Press and release the (+) or (-) for the display to
appear "CA1", then press and release the SET button
once. "TESC" will appear in the display to indicate
the remote control is now cleared and ready to be
paired to the valve control.
Pairing the handset to the TESC valve
• Confirm all batteries are fresh and correctly installed.
• Set the valve master Power switch (I) to ON.
• Place the handset within 1 meter (3 ft.) of the stove.
• Simultaneously press and hold both (
buttons on the Control Valve (not on the handset)
until the LED illuminates solid RED. Immediately press
the ON (Power) button. The handset will chirp and
- - L
display ( ). See Fig. 25.
• Grasp the remote control to illuminate the GREEN
light and enable keypad commands to the burner
control valve.
• Press "SET" with your other hand to complete the
pairing.
• Adust time and temperature settings as previously
described.
As indicated earlier in this manual..
N.B. If the display returns to the word "TESC", as shown
above, too much time as passed before pressing "SET"
and the pairing has failed. Repeat the pairing procedure
from the beginning.
N.B. Never press the (+) and (-) simultaneously, except
when pairing. Unless initializing pairing, this action will
cancel synchronization and require resetting the remote
control to factory settings,
20
Fig. 24.
+ -
) and ( )
.
Fig. 25.