Removing The Hard Disk Drive; Inches Or A Solid State Disc (Ssd)) - Fujitsu CELSIUS W570power Operating Manual

System expansions
Removing the hard disk drive (size: 2
or a Solid State Disc (SSD))
► Open the casing (see
► FUJITSU Workstation CELSIUS W570power+ / W580power+: Open the drive
cage (see "Open the drive cage", Page
"Pull the drive cage out of the casing.", Page
► Disconnect the cables connected to the hard disk drive.
► Place the device on its side as shown below.
1
1
► Press the EasyChange rails slightly together (1).
► Pull the hard disk drive out of the drive cage in the direction of the arrow (2).
► Pull the EasyChange rails off the hard disk drive.
► If you no longer need the EasyChange rails, secure them again at their location in the drive cage.
► FUJITSU Workstation CELSIUS W570power+ / W580power+: Reinsert the drive
cage into the casing (see
close the drive cage (see
► Close the casing (see
► Position the device vertically again.
If necessary, you must adjust the entry for the drive accordingly in the BIOS setup.
60
"Opening the casing", Page
38) and pull it out of the casing (see
"Slide the drive cage into the housing.", Page
"Close the drive cage", Page
"Closing the casing", Page
/ inches
1
2
35).
39).
2
41).
36).
40) and
Fujitsu