System expansions
Removing an M.2 module
► Open the casing (see
► If necessary, remove the front fan and long component groups for easier installation (see
"Removing and fitting the front fan", Page 69
► Undo the screw (1).
► Pull the M.2 module (b) slightly at an angle in the direction of the arrow (2) and out
of the slot (a) on the mainboard and remove it from the casing.
► If you have removed the front fan and long component groups: Refit these components (see
"Removing and fitting the front fan", Page 69
► Close the casing (see
If necessary, you must adjust the entry for the drive accordingly in the BIOS Setup.
76
"Opening the casing", Page
"Closing the casing", Page
35).
and
"Removing a board", Page
a
and
"Installing a board", Page
36).
73).
1
2
b
71).
Fujitsu