Advanced Setup - SKC Quick Take 15 Operating Instructions Manual

Advanced Setup

Intermittent Sampling
Intermittent Sampling allows the pump to be programmed to
run for a specific number of minutes up to 999, to shut off for
a programmed length of time, and to continue sampling on
and off for a predetermined number of cycles (e.g., program
the pump to run three cycles (n) of 15 minutes each (r) with
a five-minute delay (d) between each cycle).
Entering Intermittent Sampling Mode
Press  or  to scroll to Intt. Press  to enter the intermittent sampling setup
mode.
Setting Run Time (r)
1. Press  or  to increase or decrease run time. The
display will flash. If no change to run time is desired,
press  to move to delay time.
2. When finished, press . Stor will flash on the display.
To save new setting: Press []. Press  to
move to delay time setup.
To ignore new setting: Press . Display will
move to the delay time.
If displayed values are not changed, the flashing Stor will not appear and
pressing  will move the display to the next parameter to be set.
Setting Delay Time (d)
1. Press  or  to increase or decrease delay time. The
display will flash. If no change to delay time is desired,
press  to move to number of cycles.
2. When finished, press . Stor will flash on the display.
To save new setting: Press []. Press  to
move to number of cycles setup.
To ignore new setting: Press . Display will
move to the number of cycles.

Digital display:
Intermittent Sampling
Digital display:
Set run time
Digital display:
Set delay time