Setup - SKC Quick Take 15 Operating Instructions Manual

Setup

Press  or  to scroll through the run time presets on the LED.
Run Time Mode
Timed Run (defaults: 15, 10, 5, 2, and 1 min)
Intermittent Sampling
Continuous Run
The user may change run time presets. See Advanced Setup, Programming Your
Own Run Time Presets.
Timed Run
Run time accumulates only while pump is running.
Timed Run mode is designed to perform one sample for
a predetermined time from 1 to 999 minutes (selected
from presets). The user starts the pump running and the
pump automatically stops running after the sample time
has elapsed.
1. Press  or  to scroll to the desired run time preset.
2. Press [] to select the desired preset. The pump
will start running and the LED will display a count
down to zero (run time remaining below one minute
is displayed in seconds with a colon). The pump will
stop and beep four times. The display will flash
Done.
3. Press  to return to the run time preset display. If
the user wishes to repeat the sample, press [].
User Options During Timed Run Sampling
Viewing battery status
Press . Display will automatically return to run
time remaining after five seconds or press  again.
Hold mode
Press [] while the sample is running to place
the pump and timer in Hold. Run time remaining
and Hold will display alternately. Press []
while in Hold to continue the sample run.
Terminating a sample and resetting the pump
Press  while in Hold. Sample Reset (rSEt) will
flash on the LED.
To terminate sample and reset pump: Press [].
To continue sample run: Press  to return the
display to Hold. Press [].
LED Display
t xx
Intt
Cont

Digital display:
Timed Run 2 minutes
:
Digital display:
Run time remaining is
2 seconds
Digital display:
Sample run completed