Installing The Boiler - PENSOTTI PCC 34-H Instruction Manual

3.3 Installing the boiler.

The appliance must be installed
exclusively on a vertical solid wall capable of
supporting its weight.
■ The boiler should be fitted within the
building unless otherwise protected by a
suitable enclosure i.e. garage or
outhouse. (The boiler may be fitted inside
a cupboard)
■ If the boiler is sited in an unheated
enclosure then it is recommended to
leave the ON/OFF switch always in ON
position to give frost protection.
■ If the boiler is installed in a room
containing a bath or shower reference
must be made to the relevant
requirements.
■ Appliance is approved for installation on
combustible walls.
In order to allow access to the interior of the
boiler for maintenance purposes, it is
important that the minimum distances
indicated in figure 1 are respected. To make
the installation easier, the boiler is supplied
with a template to enable the pipe
connections to be positioned prior to fixing
the appliance to the wall.
To install the appliance, proceed as follows
(see fig. 2):
a. Use a level (of not less than 24" long) to
mark a horizontal line on the wall where
the boiler is to be fitted.
b. Position the top of the template along the
line drawn with the level, respecting the
distances indicated. Then mark the
centres of the positions of the two wall
screws or anchors. Finally, mark the
positions of the water and gas pipes.
c. Remove the template and install the
domestic hot and cold water pipes, the
gas supply pipe and the central heating
pipes using the fittings supplied with the
unit.
Fix the boiler to the wall using the bracket
and connect the pipes.
INSTALLATION INSTRUCTIONS
Fig. 2
L
X
MINIMUM DISTANCES [INCHES]
Model X Y L
PCC 34 2.5 2.5 16
Y
H A B
40 14 12
Fig. 1
20