Installing The Boiler - PENSOTTI PCH 18 Instruction Manual

3.3 Installing the boiler

■
The appliance must be installed
exclusively on a flat vertical solid
wall capable of
weight.
■
The boiler should be fitted within the
building unless otherwise protected by
a suitable enclosure i.e. garage or
outhouse. (the boiler may be fitted
inside a cupboard.
■
If the boiler is sited in an unheated
enclosure then it is recommended to
leave the power on to give frost
protection (frost protection is active
even with On/Off
position).
■
If the boiler is installed in a room
containing a bath or shower reference
must be made
requirements.
In order to allow access to the interior of
the boiler for maintenance purposes, it is
important that the necessary clearances
indicated in figure 1 are respected. To
make the installation easier, the boiler is
supplied with a template to enable the pipe
connections to be positioned prior to fixing
the appliance to the wall.
To install the boiler, proceed as follows
(see fig. 2):
a. Use a level (of not less than 24" long)
to mark a horizontal line on the wall
where the boiler is to be fitted.
b. Position the top of the template along
the line drawn
respecting the distances indicated.
Then mark the centres of the positions
of the two wall-plugs or anchors.
Finally, mark the positions of the water
and gas pipes.
c. Remove the template and install the
cold water pipes, the gas supply pipe
and the central heating pipes using the
fittings supplied with the boiler.
Fix the boiler to the wall using the wall
plugs or bracket and connect the pipes.
INSTALLATION INSTRUCTIONS
supporting its
switch in Off
to the relevant
with the level,
Fig. 2
MINIMUM DISTANCES [INCHES]
Model
PCI 18
12
L
X Y
X Y L H A
2.5 2.5 16.1 40 8
Fig. 1
B
12