Indicators In The Connection Area - Leuze electronic DDLS 508 Operating Instructions Manual

1
1
Figure 3.7: STATUS LED in the optics area
Table 3.4:
LED Color
STATUS Green
LED
Green
---
3.3.3

Indicators in the connection area

For the status display of the Ethernet connection, the device is equipped with a split, two-colored LINK/
ACT LED in the connection area.
The LINK/ACT LED indicates the same state as the LINK LED in the control panel.
Leuze electronic
STATUS LED
Meaning of the STATUS LED display
State Description
Continuous Not a warning or error message.
light
Flashing There is/are warning message(s) (see chapter 7.2):
Data transmission is active.
OFF
• SIGNAL QUALITY indicator without green LED in operating
modes AUT (Automatic), MAN (Manual), ADJ (Adjust)
• Temperature, warning or error (TMP)
• Laser pre-failure (LSR)
• Link Loss Counter has triggered (LLC)
• No supply voltage.
• SIGNAL QUALITY indicator shows only red LEDs.
• The LINK and LINK/ACT LEDs are off.
• The transmitter is deactivated (see chapter 7.2).
DDLS 508
Device description
17