Vertical Mounting (Lifting Axis) With The Alignment Laser - Leuze electronic DDLS 508 Operating Instructions Manual

NOTICE
Do not change the mounting position of the device that was mounted first!
 When aligning the second device, note that the mounting position of the device that was mounted first
must not be changed.
 Switch off the alignment laser of the second device.
Activate the AUT (Automatic) operating mode to switch off the alignment laser (see chapter 6.1).
 Remove the drilling template from the device that was mounted first.
This concludes the mounting of the devices in the travel axis.
Further procedure:
• Perform the fine adjustment for the travel axis (see chapter 6.2 "Fine adjustment").
4.2.2

Vertical mounting (lifting axis) with the alignment laser

NOTICE
Vertical mounting only with the target spot of the alignment laser!
 For the vertical mounting of the devices, only the target spot of the alignment laser is used (see
figure 4.4).
The level and laser spots 1 ... 4 cannot be used.
 Mount the two devices opposite one another with a lateral offset of 30 mm.
Mount the devices so that the center of the transmitter of one device is opposite the center of the recei -
ver of the other device.
1
Figure 4.8: Lateral offset of the devices with vertical mounting
Leuze electronic
30 mm
Lateral offset 30 mm
DDLS 508
Mounting
26