Leuze electronic DDLS 508 Operating Instructions Manual page 27

 Determine the vertical mounting position of both devices.
Place an alignment straightedge or level on top of the planar support surfaces in the connection area of
both devices.
Move the devices until they are at the same height.
 Determine the horizontal mounting position of both devices.
Place an alignment straightedge or level on the lateral support edge of one of the devices.
Move the devices towards one another horizontally so that there is an offset of 30 mm between them
(see figure 4.9). The transmitter of one device is positioned opposite the receiver of the other device.
Figure 4.9: Mounting with offset housings
Mounting of the device is concluded.
Further procedure:
• Connect the devices electrically (see chapter 5 "Electrical connection").
• Perform the fine adjustment for the travel axis (see chapter 6.2 "Fine adjustment").
Leuze electronic
30 mm
DDLS 508
Mounting
28