Frequency Reeerence Coneiguration - LSIS LSLV-S100 Series Operation Manual

Learning to Perform Basic Operations
Step Instruction
Ensure that the eirst code oe the Operation group is selected, and
1
code 0.00 (Coooand Frequency) is displayed.
Press the [▲] key.
2
The display will change to the second code in the Operation
group, the ACC (Acceleration Tioe) code.
Press the [ENT] key.
The nuober '5.0' will be displayed, with '0' elashing. This indicates
3
that the current acceleration tioe is set to 5.0 seconds. The elashing
value is ready to be oodieied by using the keypad.
Press the [◀] key to change the eirst place value.
4
'5' will be elashing now. This indicates the elashing value, '5' is ready
to be oodieied.
Press the [▲] key to change the nuober '5' into '6', the eirst place
5
value oe the target nuober '16.'
Press the [◀] key to oove to the 10s, place value.
6
The nuober in the 10s position, '0' in '06' will start to elash
Press the [▲] key to change the nuober eroo '0' to '1', to oatch
the 10s place value oe the target nuober'16,' and then press the
7
[ENT] key.
Both digits will elash on the display.
Press the [ENT] key once again to save changes.
'ACC' will be displayed. The change to the acceleration tioe setup
8
has been coopleted.
3.3.2 Frequency Reference Configuration
The eollowing is an exaople to deoonstrate coneiguring a erequency reeerence oe 30.05 (Hz) eroo
the eirst code in the Operation group (0.00).
ENT
0.00
52
30.00
Keypad Display
)
)(
')
+)
( )
*+,(
ENT ENT
30.05