Cab Control Switch; Control Switch On Fender; Use Of Switches - Zetor 8621 Forterra turbo Operator's Manual

CAB CONTROL SWITCH

Cab control switch is used for lifting the
implement when turning the tractor in the
end of field. Pressing the switch lifts
implement. Implement is lowered into
previous position destined by inner
circuit lever after turning the switch into
off.
HYDRAULIC SYSTEM
F 159

CONTROL SWITCH ON FENDER

Control switch on
attaching the implement easy. Driver can
handle movement of three point hitch
lower links from outside. The hitch is
lifted when the switch is pressed. The
implement is lowered into previous
position destined by inner circuit lever
after releasing the switch.
When the tractor is equipped
witch pick up hitch do not lift the
rear three point hitch by switches
on fenders up to the highest
position! Danger of damaging the
hitch!
111
F 160

USE OF SWITCHES

fender makes Operator must stand outside the
operating range of attached im-
plement when manipulating with
three-point hitch by means of
electrical
catching by implement or injury.
For lifting the implement into transport
position you must use the control lever
of inner circuit. Move the lever into upper
position.
lowered to ground when stopping the
tractor with attached implement (the
implement must not be left in lifted
position).
F 161
switches to avoid
The implement must be