Table of Contents
Advertisement
FLOATING POSITION
Position of control element (4) under
mark "F" and position of control element
(7) at symbol serves for the permanent
work with floating position of hydraulic,
for example when working with plough
and supporting wheel.
USE OF REAR OUTER CONTROL
Rear outer control serves only for at-
taching and disattaching the agricultural
implements. Symbols for marking of but-
tons correspond to the sense of moving
the three-point hitch after pushing but-
tons. Movement of three-point hitch
takes only the time when the button is
pressed. There is not a limitation of up-
per position saved by regulation system
when the rear control is used. Lifting is
ELECTRO-HYDRAULIC
F 187
limited by a mechanical stop (by stop on
lift cylinder).
Rear control must not be used in
the upper part of three point hitch
movement.
Each use of rear control causes the
repeated blocking of regulation system
and it is necessary to repeat ' Cancel-
lation of blocking„ " see chapter ' Can-
cellation of blocking„.
127
F 188
BUTTONS
OF
HYDRAULIC
OUTER CONTROL
1. lifting
2. lowering
Movement of three-point hitch takes only
the time when the control button is
pressed. Operator must stand outside
movement range of attached implement
when manipulating with three point hitch
by buttons to avoid grabing by imple-
ment.
F 189
REAR
Advertisement
Chapters
Table of Contents
