Front Wheel Toe-In At Front Axles (Non-Driven, Driving) - Zetor 8621 Forterra turbo Operator's Manual

SETTING THE FRONT WHEEL TOE-IN

FRONT WHEEL TOE-IN AT FRONT AXLES (NON-DRIVEN, DRIVING)

- Turn the steering wheel between both margin positions so to have a lever of
hydrostatic steering aligned with the longitudinal axis of tractor.
- Loosen lock nuts of steering rod joints
- Measure the distance between outer or inner sides of tires in front in the
horizontal plain of wheel axis. Mark the measuring points.
- Drive the tractor so that the marked points will be in rear horizontal position
(turned by 180") and again measure the distance between marked points
- Set the steering rods so to receive after setting the following differences
measured in front and rear:
- at non-driven axle 3 to 9 mm (A)
- at driving axle 0 to 2 mm (B)
- Maximal difference of turns at both steering rods can be 1 turn taking the starting
position into consideration after setting the toe-in.
- Screws for setting the tread must be in downward after setting the toe-in.
- Surfaces of joins with grease nipples must be parallel at setting.
- Tighten the lock nuts of ball joints by torque 122 - 136 Nm .
F 215
150