NuWave 31201 Manual & Recipes page 12

Operating Instructions
Check Before Closing
• Check and make sure O-ring is in groove. Do
not use the NuWave PPC if the O-ring is not
in the correct position. See Figure 4.
• Check to make sure that the pressure
indicator can move freely, by pushing it
upwards. If it moves back easily, it will
function properly.
• Ensure that the O-ring safety valve is clean
and not damaged.
• Remove the pressure regulator device
and make sure that ventilated pipe is not
blocked. You should be able to look through
the ventilated pipe if it is clear. Clean the
anti-clogging nut and safety valve with
warm water. See Figure 5.
• Check to see that the rubber gasket is
correctly in place inside lid.
General Cooking Instructions
• Moving and positioning the NuWave
Precision Pressure Cooker settings.
• Place NuWave PPC on heat source
with a diameter of at least 7 inches (18
centimeters). When using a gas stove, make
sure that the width of the flame does exceed
the edge of the NuWave PPC base.
• There are 4 positions for user to set. Align all
positions with the Position Indicator (∆) to
engage. You may use low-pressure position
(1) and high-pressure position (2). The Steam
Release position (
release of built-up steam. See Figure 6.
• The Regulator Removal position (ø) will
remove the module for cleaning purposes.
See Cleaning & Maintenance.
12
Operating Instructions
) permits the quick
Figure 4
Correct
Figure 5
Figure 6
- Control Module of Pressure Regulator
ø
= Regulator Removal Position
= Steam Release Position
1 = Low Pressure 7.3 psi
2 = High Prssure 13.1 psi
Incorrect