Set Up Your Mangoh Red Hardware; Mangoh Layout - mangOH Red Getting Started

3: Set Up Your mangOH Red Hardware

Module slot
Diversity antenna
connector
Main antenna
connector
Rev 2 8/23/17
In this chapter, you will set up your mangOH Red to begin developing applications.
A typical mangOH Red kit includes:
• mangOH Red board
• CF3 (Common Form Factor) module, cover, and release tool
• micro-USB cables (2)
• Antenna (main)
• Antenna (diversity)—Included if the CF3 module supports LTE
• Sierra Wireless micro-SIM

3.1 mangOH Layout

The following image indicates where you will connect typical kit components to the
mangOH Red— follow the instructions in
setup procedure.
SIM card slot
(bottom side of board)
9
Hardware Setup on page 10
SW401 dipswitches
CF3 USB connector
(bottom side of board)
Power Header
and jumper
CONSOLE USB connector
3
for the proper
41110481