mangOH Red Getting Started page 12

mangOH Red Getting Started
Rev 2 8/23/17
6. Attach the main antenna and (for LTE CF3 modules) the diversity antenna.
Note: The main antenna is required if you want to connect the mangOH Red to a mobile
network in Connect To Mobile Networks on page
Diversity
GNSS
Tip: If you have trouble connecting an antenna, make sure it is positioned directly on the
connector and push straight down. The antenna will not connect at an angle.
Note: The mangOH Red has two USB connectors. CF3 USB is used for SSH connections, AT
commands, and firmware downloads, and CONSOLE_USB is used for serial USB connections
for debugging and to access the module's console.
7. Move the power select jumper to select the CF3 USB connector—in this guide,
power is supplied from the dev machine's USB port to this connector.
12
29.
Main
CF3 USB connector
(bottom side of board)
CF3 USB power (jumper on pins
closest to battery connector)
CONSOLE USB connector
Battery connector
41110481