mangOH Red Getting Started page 45

Rev 2 8/23/17
Note: This may take several minutes to run.
Note: This 'make' command uses the Makefile in $LEGATO_ROOT to build the entire
system.
7. Verify that the update file mangOH_Red.wp85.update was created:
$ ls -al *.update
8. Make sure the mangOH board is powered on and is connected to your dev
machine—the board is connected if you receive ping responses:
$ ping 192.168.2.2
Press Ctrl+C to return to the command prompt.
9. Install the Project mangOH applications on your mangOH board:
$ instsys mangOH_Red.wp85.update 192.168.2.2
If the applications install successfully, the last message shown will be
"SUCCESS Done".
10. After the installation is done, open a terminal window and connect to the
mangOH Red:
$ ssh root@192.168.2.2
45 41110481