mangOH Red Getting Started page 28

mangOH Red Getting Started
Rev 2 8/23/17
h. In the terminal window, go to the Downloads folder and install the new
firmware (replace <file> with the name of the file that you downloaded):
$ cd ~/Downloads
$ fwupdate download <file> 192.168.2.2
Note: This will take several minutes to run.
n
3. As indicated in the response on the previous step, wait (1–2 minutes) while the
module reboots with the new firmware. (If you still have your console terminal
window open, you will see when the device has finished rebooting.)
4. Verify that the firmware updated:
a. Connect to the mangOH Red:
$ ssh root@192.168.2.2
b. Display information about the CF3 module and confirm the new Firmware
version is listed:
# cm info
c. Disconnect from the mangOH Red:
# exit
5. If you did this firmware update as part of the instructions in
Legato Platform and mangOH Red Platform on Target on page
on page 25.
28
Build and Install
23, go to Step 7
41110481